Quote from: V3XED on February 24, 2018, 09:19:02 PM

Quote

NP. Hub price was really good and has better slot orientation so you can use each other instead of omitting two. Should work good. You're going to face only power and noise issues.

Meanwhile I advice you to find a way how to isolate entire hub from vibrations because fans can go really loud and hub lying directly on table make terrible noise. I had to put a piece of foam underneath to eliminate the contact rattling (and hear only the fans). Best way is remove the original fans and use one bigger to cool them all.

BTW nice mockup, is this 3D? Looking good. Did you made the stick model by yourselves?

Thanks!! The 3d model is my own, though it was done very quickly and is very sloppy. The only accurate things on the sticks are the overall dimensions like width, length, depth, and fan protrusion, heat-sink protrusion, etc.
The rest is guesstimated because I was too lazy to measure or model it accurately.

As for the hub, it arrived today!!! Turns out the box was damaged, but it was actually a brand new unopened unit for 17$ after shipping. Total steal.
I am also happy to report that it is up and running 4 moonlander2's with no issues. Well, other than counter-weighting the hub to stop it from falling off my window sill.
Going to start tweaking voltages too see how high I can get the hash rate on here. but I think this is going to be a very good permanent setup for me.

https://i.imgur.com/Gnk7aBa.gifv

Any problems running 4 Moonlander's?