Quote from: volosator on September 12, 2013, 01:38:03 AM

Quote from: mjgraham on September 12, 2013, 01:34:22 AM

Quote from: volosator on September 12, 2013, 01:14:55 AM

R1 = 1.2K
Q1 = 16Mhz

No longer works in raspi + DUB-H7 setup, cgminer sees the device, not able to run it properly, I suspect lack of power (5 other devices are running in the hub, this one plugged into "high current" port)
On standalone PC cgminer 3.4.2 sees and runs, not able to get over 350Mh/s with icarus-timing short

Bitminter on Ubuntu reports response time of 6ms and 447.9Mh/s hash rate, average is 447.0Mh/s.

Is it what everybody got or I've done something wrong?

I don't think the options in the newer version of cgminer work anymore, I think someone said 3.1.1 was the last version that they worked in, I did not test it, but all versions of bfgminer I have used works fine with the -S all option

Switched to bfgminer 3.1.4; will post results soon. Miner feels very hot.

UPDATE:
ICA 0: | 587.6/441.8/382.4Mh/s | A:127 R:0+0(none) HW:34/ 21%

im would think that a 1.2K resistor is to small and yu are undervolting the chip for that speed. i would suggest a 1.35K ohm (ish).

also yes make sure you are cooling them with a fan at least.

but at 16Mhz and upto 1.3v i have ran my sticks for days with little errors using a desk fan for cooling. cgminer 3.4.1+ using the --icarus-timing short=90 option