Quote from: xyzzy099 on September 18, 2013, 08:55:13 PM

Quote from: Swimmer63 on September 18, 2013, 08:49:57 PM

Quote from: enginehead on September 13, 2013, 06:15:53 PM

Quote from: ezview on September 13, 2013, 07:35:12 AM

Quote from: RicRock on September 13, 2013, 07:21:59 AM

not enough subnet mask to go from 192.168.x.x to 10.x.x.x

Do you have a separate switch? You can manually change your PC's IP address to be 192.168.1.x just so you can connect to blade and change it's config

Yes, thx and just got pc to show 192.168.0.1 as gateway, however, I never got docs with new blade and do not know the blade IP plus if it is 192.168.1.x I am still off some with 192.168.0.x.

Also, good idea to change the blade and then can go back to 10.0.0.1 if needs be.

thx

ip should be 192.168.1.254 as long as your router gives that range. 1-254

I am trying to connect a blade to my office network and I think I have a similar issue to above.
The Default Gateway is 192.168.0.1. The router goes to 254.
But I can't access the config page using 192.168.1.254:8000 or 192.168.0.254:8000. Tried from both a wireless and direct connection on a networked PC. The blade is plugged right into the router and it's flashing green.
Any suggestions?

You need to be on a network with 192.168.1.x. Can you temporarily change your router's IP address to 192.168.1.1 instead of 192.168.0.1? You will be able to connect if you do that.

EDIT: You will need to change your PC's IP address to 192.168.1.(whatever) also. If you want to stay on the 192.168.0.x net, you can change the blade to 192.168.0.x, and then set your other IPs back to normal.

OK -thanks for the info. That will be challenging.