Quote from: thehypnominer on March 06, 2018, 02:26:45 PM

Quote from: sidehack on March 05, 2018, 02:18:16 AM

Well heck, looks like you got the very first one off the line. Check that serial number.

If it's detecting all 8 chips, the issue almost has to be with your hardware or software setup rather than the miner. Those numbers don't make sense to be a miner issue.

I'm honored!

Also, I solved the issue. Turns out that (maybe just with my particular setup) the Terminus really dislikes USB 3.0 ports. I tried 3.0 ports both on the case and mobo and it always seemed to be capped out at hashing about 10GH regardless of the frequency or V. However, when I plugged it into one of the mobo 2.0 ports it immediately began hashing about 75GH at 175Mhz - right where it should be.

So it turns out that I shouldn't have spoken so soon. I only managed to get it working for a short time. Now cgminer is failing to detect any of the chips on the Terminus. My log file reads as follows:

[2018-03-07 14:20:34.593] Started cgminer 4.10.0
[2018-03-07 14:20:34.858] GSE 0: Terminus BM1384 Bitcoin Miner (10030000)
[2018-03-07 14:20:35.064] GSE 0: found 0 chip(s)
[2018-03-07 14:20:35.064] Probing for an alive pool
[2018-03-07 14:20:35.064] GSE 0 failure, disabling!
[2018-03-07 14:20:35.065] GSE 0: setting frequency to 100.00MHz
[2018-03-07 14:20:35.299] Pool 0 difficulty changed to 4000
[2018-03-07 14:20:35.323] Pool 0 message: Authorised, welcome to solo.ckpool.org
[2018-03-07 14:20:36.066] Network diff set to 3.29T
[2018-03-07 14:20:41.322] GSE 1: Terminus BM1384 Bitcoin Miner (10030000)
[2018-03-07 14:20:41.527] GSE 1: found 0 chip(s)
[2018-03-07 14:20:41.527] Hotplug: GekkoScience added GSE 1
[2018-03-07 14:20:41.527] GSE 1 failure, disabling!
[2018-03-07 14:20:41.530] GSE 1: setting frequency to 100.00MHz
And so on and so on...

I'm using the most recently posted build of cgminer, and I have tried reinstalling and troubleshooting the Zadig drivers. Any suggestions?