Quote from: LarryFossil on September 19, 2013, 02:56:26 AM

Quote from: Stack on September 19, 2013, 12:54:37 AM

Quote from: LarryFossil on September 18, 2013, 10:25:56 PM

Update 3:

I switched around my + & - and put them in series with the ASIC chip. I turn on PSU; Fan starts up then quits & the PSU shuts off. What could be my problem? I am using a 12V rail that is meant for 12A and I only need 1.2Watts / 10Amps per blade.

Problem:
Led light behind the ethernet port starts blinking when I initially power the board, but it shuts off.
PSU works when not connected to ASIC board.
PSU Specs: https://www.dropbox.com/s/9ymyq88joxuv38o/2013-09-18%2011.08.39.jpg

Possibilities:
Bad PSU
Pulling to many amps from ASIC board
PSU not supplying advertised voltage

Other:
Fuse is working (tested em with diode checker)
Fans come on when not plugged into ASIC (using other 12V Rail to power the fans)
Only reading about 11.5-11.3V on multimeter when no fans are plugged in.
No smoking of the equipment as of yet =P

That doesn't sound right. Don't they need 120Watts per blade? as per OP

Yea, Your right. That is a typo. Its suppose to be 1.2Volts @10 amps / 120 Watts, but thanks for the help..

Update 4:
I found out my PSU problem with the help of Wizkid on IRC. He gave me the idea to connect my two 5v extra wires to a 5-6v fan. (Older PSU's won't work properly unless power is distributed.) I joined both 5v wires from the modified molex splitter (per OP) & used one ground wire from same rail to power the 6v fan. Plugged it in and boom everything worked. Including the two 120mm fans I have on another rail.
Seen IP connectivity and Connected to the ASIC through the browser at ease =P Now, I need to figure out how to input the settings perfectly =P to mine on slush's pool. Hopefully that is a bit simpler... I have been fiddling with this stuff since yesterday. Should of been much simpler, but I paid 50 bucks for a cheapo pwr supply and ended up wasting valuable time cause of a different power distributing configuration.

Update 5:

Got both ASIC Blades up and running
The second ASIC i have, only runs at about 8gh/s... There are currently 4 x' when I connect to the config page. (Where do i check the voltages on each module to see if its a voltage problem or a power module problem?
Connected em to proxy & everything looks like its working for the most part =)
Now, I gotta take all the equipment and organize it =P
More pictures soon To Come. Also will be creating a better tutorial / Guide... I found this one very very outdated & not specific at all.