Quote from: fuaimo3 on March 10, 2018, 05:38:22 AM

Quote from: 1manshow on March 10, 2018, 04:52:33 AM

Quote from: fuaimo3 on March 10, 2018, 04:14:22 AM

Quote from: 1manshow on March 09, 2018, 11:28:52 AM

I want to use this pool for my Baikal Giant X10, does anyone know the proper configuration parameters for this device? I tried instructions from previous posts but miner gets down several times and very low earnings over few hours. There is not much help documentation available on the pool website itself. Undecided

Earnings should be measured in 24 hour increments for better accuracy. Yesterday was a great day on the pool still pull over 25 per miner per day on the x10.

First field put your wallet address next in password field put c=btc,quark,qubit,myr-gr,skien=.5

Then add each algo server so it will need 4 spots. There's config info here as well to better explain.

https://bitcointalk.org/index.php?topic=2170308.2460

First of all, let me thank you for reading and replying to my post. Very much grateful to you for your help.

I already configured according to that post, just used LTC as coin but my past 24 hour earnings were meager as you can see from this address - https://www.starpool.biz/?address=LiE3WVDzcWBg3T9aZpwTcX9i74V9Pp6gke

Can you please show me your Baikal X10 miner settings page screenshot so that I can check and review what I did wrong? Since configuring this pool details yesterday, my miner is unable to stay online for more than 5 mins and most of the times it's miner down. Mining pool hub and nicehash never had this issue with same miner when configured, they could simply run forever. Any way I can reset the miner to factory defaults other than reflashing via SDcard? I can do SSH access and run commands if required.

Thanks for your help once again, hope I can do the same like you on this pool soon.

Weird, non of my miners ever go down due to the pool just to getting stuck between switching. Maybe you have a dud?

Anyway under user I just have my wallet address, under pass I don't use a factor of 1 like they show configured in the post, I use the built in factors only cutting skien in half due to 5ghz rate limit.

so my pass looks like this: c=BTC,quark,qubit,myr-gr,skein=.5

Then I simply have the 4 servers added with that password entered in each for the auto algo switching. I have 100 percent up time for nearly a month. Good luck.

Thanks for your help mate. I've reflashed new firmware for X10 from December via SDCARD and it works fine thereafter with pool, let's see how it pans out for next day. Hope it earns better than MPH which I was using for this past month since getting this miner.