Quote from: nolan11 on March 12, 2018, 10:43:02 PM

Hi all,

I have a problem; 2 Miners /6 GPUs each/, 2 power supplies 750W per Miner.
2 Miners together take less than 1500W.
It is connected to power extension for the current C16 fuse (earlier it was B16 and was changed to exclude something). 16 Amper.
Miners work normally, both. Until I turn off the extension or one of the Miners will freeze (then it also ends with turning off the extension out of electricity).

In addition, the same situation would be if I cut off the remote socket on WiFi which I planned to install.

After switching ON the extension -> it breaks the plugs, it just breaks the previously mentioned C16 fuse.

I need to put it back again manually.
After that, to properly start the Miners - I need to unload the capacitors on disconnected cables by pressing the power Miner button.
Only then, it does start and work without problem.
So I have no idea then... why...

What could be the reason ? Where to look for a fault? What to check?

Poor Risers? Replace the Risers?

Thank you in advance.

try with 4 gpus on each miner if it works it is an overload issue

I know sometimes gpus turn on at 100% not say the 70% setting you may have.

so 4 gpus each should keep you under overload.