Quote from: MinLum on March 13, 2018, 06:51:18 PM

Quote from: Nexillus on March 13, 2018, 06:21:12 PM

Are you only looking to pass the dev=0,1,2 command through AM to DSTM miner? (I will be home in about an hour and will get back with you)
Also AM can individually enable/disable GPU's as well if that is the objective you are trying to do.

Yes, just that. I just want to enable/disable GPUs as I'm planning to do some testing and want to run AM and NH at the same time.

Quote from: paramecie on March 13, 2018, 06:25:45 PM

I don't know for DSTM but in general with miners, either you use the config file (the simply run the exe with ZERO parameter), OR you pass parameters, in a batch or cmd file.
In general, you CANNOT do both.

If you've some specific parameters, then you may try to rename the config file as *.old for example, and pass ALL the parameters with AM.

Well, I was trying with both the dev command through AM and in the .cfg file with no luck. At this moment, I've taken out all instructions from AM but the dev command is still in the .cfg file, still does not work.

Go to Options->Profit Profiles. In the Profit switching profiles select the profile that applies to you, in my case "nVidia GPU". Then select "Edit" Click on the miner you want to use. Click on it, click Configure. Then Select "new" in which at this point you can specify the number of GPU's you want to use or detect from host per device.