Quote from: pyroandy on March 18, 2018, 03:30:13 PM

Quote from: scoobysportD on March 18, 2018, 12:32:16 PM

Currently i've got them running at 900mhz, i gotta say, the MLD's run smooth and stable!!

The newly placed win10 laptop and wifi connection is a different story though. Hope i got that fixed and have stopped win 10 auto updates.
Currently am using fans from HAMA and Arctic:

And this is them running after a reboot of the laptop:

With these fans the temps seem to stay between 42-54 degrees celsius. (2 ara within the 42-45 degree range, one runs a lot hotter maybe this one had a bit less luck with the ASIC chip on it.

Amps drawn are between 2.2 - 2.5.
The fans are powered through a separate powered usb hub so that i'm a 100% sure they won't cause any interference. Now i just got to wait for the new shipment to get here Sad

BTW; @jstefanop:
What i'd love to see in BFGminer / the MLD's if possible; a way to identify them. BFG sets them up as MLD 0, MLD 1, MLD 2.... etc. But there's no way of telling (as far as i am aware of) to figure out which stick is MLD 0 or MLD 1 etc. Troubleshooting can be made so much simpler with unique ID's. After a reboot, the ID's get swapped now so MLD 0 could then be MLD 2 etc. I know that my gridseed dual miners had unique ID's, so if you plugged them in 1 at a time, you could make a note of which ID that miner had and if there ever was a problem you knew exactly which miner to fix.

Would not MLD 0, MLD 1, MLD 2.... etc be assigned to a particular USB port and stay there after the initial setup?

Not as far as i can tell Sad

when taking out one of the MLDs to adjust voltage it gets assigned a different number...