Quote from: ummas on October 22, 2013, 02:28:02 PM

just got my stuff - 6 boards
puted it together
and connected with 1 usb cabel and a CAN cable
What need i do to run them all, just one unit works

Check out these tutorials:

http://www.burninmining.com/assembly-instructions-part1/
http://www.burninmining.com/assembly-instructions-part-2/

Quote from: Tamerz on October 22, 2013, 02:32:13 PM

Quote from: SebastianJu on October 22, 2013, 02:03:57 PM

Quote from: Tamerz on October 22, 2013, 12:03:01 PM

OK with my settings I'm getting this:

Code:

BTB 0: 38C 450 1339mV | 5.624G/4.472Gh/s | A: 25954 R: 322 HW: 54 WU: 62.5/m
BTB 1: 57C 450 1371mV | 11.66G/8.966Gh/s | A: 55200 R: 362 HW:145 WU: 125.3/m

That seems like a reasonable error rate and hash rate correct? The BTB 0 is the 10 chip and the BTB 1 a 20 chip.

Really good result so far... whats your settings? And what pool do you use?

Code:

--avalon-options 115200:2:10:28:450 --bitburner-voltage 1334 --avalon-temp 30 --queue 4 -G

Currently running on BTC Guild. I was using Eligius but for some reason I can't connect to it with cgminer anymore.

Thats the settings i used with my old 5 bitburner too since i optimized it to the mV. And i got similar results. And someone i sold bitburners too get the same good results too. I dont see whats the problem.

I mean its the same place they are placed, settings are same, cgminer is newer, psu is burnins partly, its rpi, though another rpi, all are flashed to newest firmware... i dont see the difference.