Quote from: nite423 on October 27, 2013, 05:18:28 AM

Quote from: bspurloc on October 27, 2013, 02:12:52 AM

Blade Eruptor

Is there anything special I need to do with the mining_proxy programming???
I can't seem to get my blade above 73% efficiency. mostly it sits at 63% efficiency
It doesnt seem to want to go over 6100mh/s grrr... plenty of power and fans. the fins are not hot.

I just got my first blade fired up a few minutes ago. I'm running this blade right off the power supply of the same PC running my USB block erupters. It pretty much shot right up to 10.9Gh/s and its rolling at 100% efficiency...give or take a percent or two.

My first guess for you would probably be power related. The proxy was probably the easiest part of getting my blade running.

What watts is the power supply? I am questioning the proxy because the first one I setup it was struggling to keep up so I set it up on 2 other pc's. I see it seems to change servers it uses for the proxy for whatever reason. I would assume because it is loses connection. but they are all in the same network. as I just typed that it changed proxy servers...