Quote from: Phoenix1969 on October 27, 2013, 06:41:31 PM

Quote from: thejestre on October 27, 2013, 06:34:46 PM

Quote from: Phoenix1969 on October 27, 2013, 06:16:36 AM

Ill bet you find the credentials are entered wrong, or something like that
was it running before?, or u just got it?

The credentials are entered fine. I'm not even trying to enter more than 1 pool.
I just received my unit. Put my info in to the .95 settings, it started hashing ~80-90 Ghash/sec. Upgraded firmware to 0.97, started hashing ~10 Ghash/sec.

I'm sure it isn't just bad credentials. Am I supposed to do anything after applying the new firmware? There doesn't even seem to be much that could be done in the web GUI. Do I need to SSH to the thing to make 0.97 work?

Thank you,

_theJestre

I had similar experience with all of the restarts, and was cured by power-cycling the machine. I highly recommend 0.97 as well... it will work.

Sometimes when hitting the warm reboot button for an upgrade, it seems to start a second instance of cgminer, and cause problems, which a power-cycle cured, this happened almost every time I reflashed.

any time I change firmware, I have to power cycle the sats.(instead of reboot)
and by power cycle, I mean physically using the power supply to turn the miner off for 20 seconds.

You may also need to clear your browser casche, and close the browser, reopen...

Well, I really would like to run 0.97 but it isn't working on my Mercury. I tried the enablecores.bin and I swear I did power cycle it by turning off the PSU. Maybe I'll try again later, trying to see if 0.96 can work better than 0.95 now.

Looks like 0.96 is a dud to me as well, trying 0.96.1 now.

Thanks for the suggestions,

_theJestre

EDIT: In 0.96.1 I saw 105 Ghash/sec for a brief minute after a power cycle, then it dropped steadily until ~10 Ghash/sec again. Is that indicative of some kind of known problem?