But also good to know the temp sensor readings are from a different location on bertmod than the normal firmware...
They are not man...
Regarding temperature sensor data, I decided to do a simple test...
Dude I've said Bertmod gives VRM temps, as has Uski.
Can you clarify regarding NON Bertmod reported temperatures? I imagine they are the same but to not leave margin for doubt here. Thank you.
Non Bertmod is from a separate temp sensor.
ok, so what's the verdict here? I'm just wondering ...
Why you think O'rama is wrong?...
Your experiment results, or info from Bertmod DEV?
Simply because O'rama was just deferring to authority (putting things in the form of "I already said" and "It is"..) without comment to the conflicting experimental results.
When experimental results contradict deferment to authority, authority is usually flat out wrong, not just a little bit.
Thank you so much dzindra and kill-switch for not only finally settling this but for going through datasheets and what not to give us all this insight into temps!
There's two temp sensors one is in the VRM itself, but some boards have an analogue DCDC which is why they may not show every statistic.Uski brought this up the other day as well in this thread, and here post#65;
http://forum.kncminer.com/forum/main-category/main-forum/6183-bertmod-0-2-unofficial-firmware-mod-feedback-thread/page5
The reason you haven't had much of a comment from me is the only time time I have to check this thread currently is via cursory glances whilst on public transport, and even then the reception and a tiny mobile screen isn't favourable.
I wouldn't put solder to your boards if you value warranty btw.