Quote from: dzindra on November 02, 2013, 09:53:02 PM

Quote from: Phoenix1969 on November 02, 2013, 09:20:36 PM

just confirming, yes.
But also good to know the temp sensor readings are from a different location on bertmod than the normal firmware... perhaps the Bertmod Dev could add the asic temp, or KNC could add vrm temps....

Based on the vrm info.. I'm trying a few things.... details later.

Both normal firmware and bertmod are using data from lm75 temp sensors (chip in red circle in the picture below). One sensor is on each mining board and one is on controller board. Differences are probably caused by refresh rate of the temp data. Stock firmware refreshes data each minute, stores them to /var/run/stats.knc and displays this file. Bertmod refreshes when requested.

Unfortunately, there is no way how to get temperature from VRMs (or at least I did not found it in datasheet)

Hmmm, so the temperature is measured on the outside of the plastic bags and cardboard that some are using to warm their chips?

Why do I smell burning ASICs? Lol.