Quote from: FatAnt on April 17, 2018, 03:51:27 AM

Did you get a chance to try those steps?

Since your router LAN IP is not the same as the V9 there shouldn't be an issue with IP address conflicts.

Do you know why you're using subnet mask of 255.255.254.0 instead of 255.255.255.0 ?
Do you know the difference between a MAC address and an IP address? Notation difference?

Were you able to reconfigure your V9?

Hello and thank you for the reply.

I did go through all those steps sadly it did not fix anything.

I was using the subnet mast 254 in order to allow my network to gain access the IP addresses greater than the 254 allotted from the 255 subnet masks. Addtionally, I was hoping that possibly by setting my subnet mask to a wider range I would be able to pick up the Antminer. Also yes I do understand the difference between MAC and IP. I even went so far as to reserve an IP address under 192.168.1.1 on my router under the MAC address of the broken antminer in the hopes that it would then communicate. Regardless this did not work.

I attempt to Flash my miners firmware using an SD card. there were no clear instructions online. I simple formated my SD card with FAT32 and pasted the firmware files provided by antminer for the V9. When I plugged in the SD card into my machine and tunred it on the fan started spinning at max speed and both the red and green led's stayed on. The Ethernet socket is blinking now which I assume means the machine is finally able to communicate. however, I still can't find the presumed DHCP IP for the new firmware. The red and green lights wont go away even when the sd card is removed after power cycling the machine. You think I may have done something incorrectly when putting the files onto the sd card?