Quote from: Spotswood on November 12, 2013, 02:27:25 AM

Quote from: xstr8guy on November 12, 2013, 02:06:48 AM

Quote from: Spotswood on November 08, 2013, 03:53:29 AM

Anyone interested in an open-air case for ASICminer blades?

Each blade is secured to the tray via a custom plastic bracket. The beam that the brackets and fans are attached to could be mounted on the opposite side.

Any comments/suggestions?

p.s. Does anyone have an accurate drawing of the backplane mounting holes?

I'm glad to see that you are thinking about doing this! But any case I'd use would need to accommodate the HP server PSU mounted on the end of the backplane. Your design doesn't seem to allow for it. The PSU is tall and top heavy and needs something to hold in place so it doesn't wobble too much if you breath too hard in the general direction.

Yep, the final product will have support for the PSU.

All I need to know is by how much the PSU overhangs the backplane and the dimensions of the PSU itself (in millimeters, please). Grin

I dont have a tape measure that shows millimeters, according to my set up, the power supply hangs off the backplane by 11/16th of an inch...

http://t.co/aRDecAPjOw