Quote from: BTClobsta on November 12, 2013, 07:40:04 PM

Quote from: punin on October 21, 2013, 09:41:19 AM

NOTE

Due to my personal epic screw-up the SD image does not contain a working binary. And on top of this some orders were shipped without instructions also Tongue

We have whipped ourselves vigorously here over the weekend and will try to improve our process so these bloopers don't happen in the future.

Here's how to get your miner working:
1. Check your router for bitfury IP
2. SSH into the raspberry pi (username pi password raspberry)
3. Run following commands:

Code:

cd /opt/bitfury/chainminer
sudo make clean
sudo make
sudo killall screen
sudo /etc/rc.local

You should now be mining. You can check the web interface of the miner with a normal browser and setup your pools there (use the IP that you used for SSH).

i followed the instructions above. now my unit keeps truning off after it loads to the login and password page. did i do something wrong? i have the US v2 Hboard

Than why are u reading the EU section ?