Quote from: anemol on November 12, 2013, 08:48:46 PM

Conventionnellement, un fichier *.log ne sert qu'à tracer l'activité d'un processus ou d'une application (comme un journal). Il n'y a aucune utilité d'aller en modifier le contenu. En général, c'est plutôt les fichiers *.conf, *.cfg, etc que l'on modifie.

hmm bien bien jusque la je te suis.. mais alors comment je change le "A" en "a"? Ou suis-je censé faire la modif comme décrite dans ce thread :

Quote from: darkfriend77 on September 04, 2013, 12:17:20 PM

FAQ Chainminer & Raspberry:

First you need to turn of autotune "A" to "a" so that they wont be turned down to 0, because right know as long as they produce to many errors, they will be turned down until 0.

To start of set there clockspeed to 55 on the bad chip and let him run for 10-15 min. Check again. If he is performing better or not ... find a good rate between good and error. You might go down to 54 or 53 ... just check again, where the bad chip is performing at his max. potential ... at the end it might look like this one ...