Quote from: Maxbet on November 16, 2013, 06:03:56 PM

Quote from: CoinGeneral on November 15, 2013, 11:44:31 PM

Quote from: Magicmike514 on November 15, 2013, 11:39:14 PM

Quote from: CoinGeneral on November 15, 2013, 11:35:39 PM

Hey Mike you don't have to post like it's a letter to someone, it's just a random forum

so you there's no formatting rules or anything

oh ok sorry :/

just trying to figure out how to open the case LOL. But i can't post in the technical mining section

Yeah I'm not sure what torx it is, they should have just used Phillip's screwdriver sizes, that would have made the most sense

No they shouldn't, torx is the better choise for this stuff.
In fact, I don't even buy philips screws anymore if I can get my hands on the same size torx scews.

More on topic: most hardware stores have sets of ~10 torx bits for a couple of bucks. Since you probably need to buy 1 bit for your rig anyway why not buy the set.

I bought a whole set of hex and torx bits but the torx was only able to take two off the back. The side screws appear to be hexagonal and i get a 3/32 to fit inside and there is good tension but when i turn i hear a snap noise and there is no tension after sort of like the feeling when a screw becomes stripped.