Quote from: pws328 on November 21, 2013, 05:41:10 PM

Quote from: charles2k on November 20, 2013, 10:46:19 PM

Quote from: Beutelschneider on November 13, 2013, 03:25:32 PM

Quote from: charles2k on November 13, 2013, 01:00:08 AM

I need to resolder dead fuse on blade V2 (green PCB). But I could not find any specification for this fuse. Do you know somebody? Where to buy it?
Please help.

Bought a few as replacement for the blue blades from a local electronics store for a few cent each! They were 10A ones.

IMHO it would be easier to solder two wires to the blade and connect them to a socket used for car fuses (the ones the gen 1 blades use)

So finally I found that it should be 8A/125V fuse from TS connectivity 2410SFV8.00FM/125-2
http://www.te.com/catalog/pn/en/RF1952-000

Great that you found those!

However I'm really curious about your other idea of just soldering in a connector that would accept auto fuses. I have a blown fuse (at least I'm pretty sure its blown) on a V2 Blade (Green PCB), and instead of re-soldering the same SMD fuse, I was thinking of soldering on an inline fuse holder like this one http://www.radioshack.com/product/index.jsp?productId=3150583&znt_campaign=Category_CMS&znt_source=CAT&znt_medium=RSCOM&znt_content=CT2032234, and adding in a 10A mini-blade fuse. Looking at the ones from TS thought, I'm worried this won't be able to carry enough voltage. I'm a little newbish when it comes to electronics, so any input would be greatly appreciated.

That's fine.. it's rated for 12-24 volts, and 30 amps. More than enough.