Quote from: philipma1957 on May 11, 2018, 03:08:03 AM

Quote from: sololoop on May 11, 2018, 02:08:00 AM

Quote from: jstefanop on May 10, 2018, 05:03:30 PM

Quote from: sololoop on May 10, 2018, 03:22:51 PM

Thx jstefanop.
Testing my ten L3+ with lowest voltage (0xfe). Currently running 400 frequency.

Can this set frequency for each board individually?
for example :
board 1,2,3 running very smooth on 450 frequency & voltage 0xc0 with less HW
board 4 cant go over 400 no mater how high is voltage (0x30) , too much HW (error every sec)

No since tuning voltage and frequency for each board is redundant and way more complicated than it needs to be. You just choose a frequency you want to run, and then tune the voltage on each board. Sounds to me like you have a faulty board....there are some boards that will just produce more errors regardless of what voltage/frequency you set (i.e. some chips just have logic defects that will produce errors even if the frequency/voltage is low/high enough).

Copy that. I got few faulty boards that must run on 384 freq or below.
I will try philipma1957 's advice to swap those faulty boards.

Thanks.

And run them gentle like freq 359 with lowest volts

Hell I got boards that have to be run at like 300 and they still cause the miner to crash. Once the L3+ start going they degrade really fast.