Quote from: HerbJones on November 25, 2013, 07:02:01 PM

Quote from: Carlton Banks on November 23, 2013, 12:55:26 AM

Quote from: HerbJones on November 23, 2013, 12:39:56 AM

Hello all,

I have been mining with a BFL 30Gh/S system and just bought an Avalon 4 Module. Tried setting it up at the office and could not get it to work with the Wifi.

I accidentally deleted the LAN config and brought it home to try and connect to my home network.

I set my Mac up to the 192.168.0.101 ip and tried using my browser to connect.... nothing - it times out.

I tried ssh from laptop - still nothing.

Is there a hard reset to restore to factory settings?

Did I brick the WR703N? If so, is my only hope to take the unit apart, solder the wire to the connection and reset?

Help!

There is a hard reset procedure, the user ckolivas describes it earlier in this thread. The instructions are also available from OpenWRT and TP-LINK on their respective websites. Note that this does not restore the Avalon factory configuration, but the base installation for the WR703N to function as a router. You will need to donwload and flash Avalon config (erroneously referred to as "firmware") from either ckolivas web repository or the Avalon wiki.

I found the post by ckolivas.

1. I set my computer to 192.168.1.2
2. I powered on the Avalon Unit and waited for the blue router light to blink and then hit the reset switch so the light blinks fast
3. Plugged in the ethernet cables
4. Tried to ssh to 192.168.1.1 - Connection timed out

I can ping and I get response.

If I telnet to 192.168.1.2 i get @root(none)

Any ideas? I'll happily pay anyone who can get my minier back up!

Thanks!

Isnt the default IP for the Avalon 192.168.0.100?

You might be logging into something else on your network.