Quote from: cypherdoc on November 25, 2013, 09:57:46 PM

Quote from: goxed on November 25, 2013, 09:20:58 PM

Quote from: cypherdoc on November 24, 2013, 02:25:22 AM

Quote from: buzzdave on November 20, 2013, 06:50:42 AM

Here's the V3 image, sorry for the delay. Please *only* download this if you have the new overclocked V3 boards. It will make previous boards run slower (clock reduced due to higher voltage).

This is not a new, improved version - its just what we shipped already, in case you get a bad SD card or your SD card corrupts.

This new image has a Shutdown button - use it rather than just pulling the plug on the power and your SD cards will do much better!

Cheers,
Dave

Wishing you all the best with your rigs and enjoy the high BTC prices!

https://www.dropbox.com/s/skr9vitueeyxwmw/miner-v3-image-11-15-2013-customer.img

has anybody tried this image successfully?

this version wasn't assigned an address by my DHCP router like the others.

I tried it with my old v1 M board. Works fine, but I think the chainminer is based on the older version, with some changes like automatic detection of v1 M board. There's a shutdown button on the web interface. miner.h was also changed to default speed 52.

it started with an IP address 192.168.0.249. I changed the IP address with . Nevertheless in my opinion, Punin's November image is better for older boards, and if you recompile with modded miner.h to 52 speed, it's golden for new boards. all IMO, please use due caution etc etc