Quote from: grid on July 20, 2011, 01:11:19 PM

[...]
The ZTEX USB-FPGA 1.15d LX-150 based, with a Cypress EZ-USB for flashing, feeding the FPGA with data and USB communication. Uses only one 24MHz oscillator, some schematics available on their site:
http://www.ztex.de/usb-fpga-1/usb-fpga-1.15.e.html

By the way the price of this one beats the Opal board I mentioned earlier. Got an email quote at a unit price of 357EUR, power supply not included.

I find it interesting because of the FX2 chip, but apart from that it has too much: extra DDR SDRAM, extra EEPROM, extra CPLD, microSD card slot. The pricetag is only a factor of 2 above what we hope to achieve (note that they are missing the power supply section and need 3 different voltage rails).

I don't know about the others, but I am in it for the fun of developing a board. The board you linked may be a very good start to get FPGA developers to write code, but once our board is go, it won't be cost effective (unless you figure their support and warranty are worth the price). I am not arguing against the board: it is good for early adopters, but eventually we should beat it.