Quote from: opies32765 on May 25, 2018, 11:24:55 AM

Guys,

I have one miner that i cannot figure out. Mind you i have 30+ but yes i cannot figure this one out, and its driving me nuts.

The issue is that after the Windows 10 April update the miner will start but pauses....it does not close. I have tried everything i know and nothing. So i went ahead and installed a clean version of 1709 build with all of its updates.

I have reinstalled 11.7(which was working with no issues prior) and still nothing. I have tried adrenaline 18.2 and even downgraded to the blockchain drivers and still nothing. The motherboard is up to date, windows sees all the cards...no issues there. I have patched the drivers...etc...etc...

These are AMD RX560's that have been modded...and again these were working fine before the darn update got me.....I have also excluded the claymore folder in defender, set a pause for 30 seconds etc...

Im hoping someone out there has run into this prior....i am now having this same issue with another rig running rx470's

Any help would be appreciated

Thanks

I have a 560 rig with windows 10 updated, if I switch to cryptonight and then back to ethash sometimes it will not work even after a reboot, I need to fully power off the rig and cold boot.
You also might have a card(s) with the mem clock too high, trying downing them by 10 mhz at a time.
Claymore 11.7 seems to be a tad more sensitive to overclocks.