Quote from: yuancraft on December 07, 2013, 09:34:12 AM

Quote from: davecoin on December 07, 2013, 07:57:10 AM

Is there a trick to getting the antminer to hold on to a reassigned static ip?

I go into the Network > Interfaces > Wan > and change the settings to an address on 192.168.1.x that is unassigned on my network, but when I hit save and apply it just hangs. I've tried a few different times now, waiting 2 min, 5 min, 10 min, and after plugging the cable back into the router, the miner hasn't been reassigned to the new address. I used the advance ip scanner utility and it still shows the same default address at 192.168.2.xx, which I can now not connect to either. After shorting the pins to do a hard reset, I can re-connect again on 192.168.2.99.

Any ideas?

you need to change you LAN before change the WAN

LAN tab change to DHCP hit switch > save&apply . wait a bit

then back to WAN tab change the ip that u want > save&apply

My LAN setting is DHCP Client by default. If we are to assign a static ip should this be changed to "Static address"?

The problem occurs when it tries to save changes. I've tried hitting save, then applying the changes later before giving the miner a reboot, and it still hangs.

This isn't a huge problem right now, as it's mining okay on wifi, but I'd still like to move it to the garage and give it a hard wired connection.