Quote from: Bitcoinorama on December 08, 2013, 07:39:09 AM

Quote from: RickJamesBTC on December 07, 2013, 06:23:32 PM

Cyper, I don't think blowing across the unit will make a big difference if you close the case. Right now you are bringing fresh air onto that board. Why don't you just strap that fan onto the heatsink on the open side working with the other fan, or switch the location of that board to one of the front slots where they get cold air from the big fans on the front. Otherwise, you could always cut a big hole on the side of the case and mount it properly.

Avenger, I didn't notice you set me straight, all I saw was some lame ad-hominem attack from a sad little boy and didn't need to respond to it. From reading your posts i honestly pity you, it must be hard to live your angry life... You probably need to go outside more, get some fresh air and sunlight.

Bitcoinorama! Good to see you again. Any idea when tuning software will arrive for November units?

No idea. I'm in the US currently. Literally just touched down in SF after a few days in NYC en route to the Vegas conference. I do know that later firmware a will have a more intelligent code that detects which device you have.

Also there will be more upgrade boards at some point. The controller boards are essentially the same albeit firmware, but you need 4x Nov boards to run a Nov box, otherwise an Oct will be detected and limited.

Damn, I should fly down to vegas to this conference! Too much going on right now Sad

Can you explain the upgrade boards? November units don't have headers for extra modules, could they be soldered in and connected to make nice overpowered ones again? If someone with an october jupiter got 4 november modules, they could flash to november software and run faster, but what of the october asics? Would this be a replacement use only? How many total ASICs can one of the controller boards run ?