Quote from: sidehack on December 15, 2013, 02:55:35 PM

Check your 3.3V either at the test header by the ethernet controller, or measure across C286 (which is an output cap for the 3.3V regulator, and should measure 3.3V at all times). Some folks that messed up resistors on the VRMs (usually missing or bad connection, haven't heard about a bridge yet) have reported that it fried that regulator.

I checked the power at the debug and C286, I am getting .8 volts at both locations, on my other devices they are all getting 3.3V at those locations. I checked the power coming in, its 12.8v, C284 is 12.8v, C285 and C286 are both 0.8v.

R120 is doing .6v but on my other units its doing 2.5v

Where do you think I should try and go from here. Sorry it took so long, I just got back from vacation.