Quote from: qwertyasdfg on December 19, 2013, 05:54:55 PM

Quote from: RaTTuS on December 17, 2013, 05:37:19 PM

ASIC_01-16: O O O O O O O O O O O O O O O O
ASIC_17-32: O O O O O O O O O O O O O O O O
ASIC_33-48: O O O O O O O O O O O O O O O O
ASIC_49-64: O O O O O O O O O O O O O O O O
ASIC_65-80: O O O O O O O O O O O O O O O O
ASIC_81-96: O O O O O O O O O O O O O O O O
if you have x's then you have a problem

see
https://bitcointalk.org/index.php?topic=352658.0

Thanks for the advice, I got allot of support from this thread.

Quote from: vm1990 on December 19, 2013, 12:15:18 AM

more than likely mot enough power id be using atleast a 700w psu for these

Deffo wasn't a power issue, 500W is more than capable of running one cube efficiently but thanks for the reply!

Quote from: midniteslide on December 19, 2013, 12:43:12 AM

Four of my five cubes do the same thing. They run perfect on low so I don't really care but I know it is not a power issue as I'm using HX1050's.

On low I have my cube running at 95% efficiency but only hashing at around 29000MHS

Quote from: NorbyTheGeek on December 19, 2013, 05:39:21 PM

I've been told that sometimes the heatsink screws on the mini-blades come loose during shipping, and that checking them all for tightness is recommended before hashing. If you haven't already, you might check that.

From the advice I received from the other thread, I opened the cube and found it not to be aligned correctly in it's structure, once I managed to get the board and blades out of it, I checked all the screws and tightened them as a few of them were loose, after I put the cube back together I only had 1 x but still wasn't able to run the cube efficiently in high clock mode, efficiency went down to 10% or less and it was only hashing at 01085MHS or thereabouts.

So once again I reopened the cube and checked the screws again, put it back together and was back to square 1 with 8 x's, I tried a final time to reopened and this time rearrange the blades to determine whether there was a problem with the actual board or the blades, turn's out the problem is with the board itself, as even after rearranging the blades the same 8 x's show up in the same row!

I have been on to the seller and he is awaiting a response from the supplier, so I'm hoping this will be sorted soon.

Thank you all for your help and advice.

Back to square 1 Sad

FINALLY today I received a new board via OC directly from yxt, now I've taken the old board out and put the new board in after switching over the mini blades and am trying to connect to it using 192.168.1.254:8000 but am unable to do so, I cannot even see the device anywhere in the wired devices section of my router!

Anyone got any advice on what I might be doing wrong here?? My routers subnet is 192.168.1.x

Do I have to flash this new board with some sort of firmware before I can use it to control the mini blades???