Quote from: 1a1a11a on June 29, 2018, 08:22:33 PM

I cannot see the temperature now because the it does not show any hashboard.

Quote from: Stubo on June 29, 2018, 08:12:57 PM

Quote from: 1a1a11a on June 29, 2018, 08:04:30 PM

The control is fine, I can still connect to it, but I can't see the hash related information again and the fan is running at maximal. I did the reset with gui. I am not with the machine, so I will have a hard-reset when I am back tonight.

Quote from: htautosjay on June 29, 2018, 07:57:54 PM

Quote from: 1a1a11a on June 29, 2018, 07:54:02 PM

Quote from: DontCallMeSir on June 29, 2018, 07:51:54 PM

Ouch. What freq did you overclock it to and for how long? Auto fan?

656Mhz, I moved it to a new place because it is too noisy to put at home, it has been running for less than 12 hours since move. Fixed fan rate until this noon, I see the temperature increased to 79 then I switched to auto fan.

That is a shame... is it a board hash down or control board?.. if board.. it could just be seeking freq...or power can cause them to loose a board... keep doing cold reboots (thats pull the power out the PSU and restart it.. I have alot of S9's and i learnt the hard way.. self taught...
Ps are all 3 boards down? or just 1?

What are the current chip temps? I was playing with how quiet I could make mine by backing off the fan speed. I noticed when I hit 74, it stopped mining (according to Miner Status page - Summary). I increased the fan speed to lower the temps and it started mining just fine.

My point is that if your chip temps are still in the 70's with the fan at auto, you need to back down the OC to bring them down so that it will start mining again.

I had the same issue, took down the OC to default and all restore stuff and nothing heloed. Then I changed pool and it all came back.....