Hello everyone. It's me again.  I am still having trouble getting my second cube connected.  By that I mean I still cannot get to the config screen to set up the cube.  Here is what I have done this morning. 

1. Plugged in the PCI power cable from my 1000 watt Zalman PSU
2. Plugged in the ethernet cable.
3. Powered on the PSU. All lights indicate on and running.
4. Pressed the Factory reset button for a few seconds (red light flashed a dozen time or so and then went steady red) 

I pushed the factory reset because I had entered the config page a few days ago and changed the IP. Then when I tried to access it again, I couldn't. So I want to start from the beginning. 

5. Opened my TCP/IP configuration and change the settings to:

IP Address:     192.168.1.1
Subnet Mask:  255.255.255.0
Gateway:        192.168.1.1

I then pointed my browser to 192.168.1.254:8000

The browser gave me an error page. So, I use the command prompt to check the ip config.

C:>ipconfig

Ip address:    192.168.1.1
Subnet Mask: 255.255.255.0
Gateway:       0.0.0.0

So, it was clear the computer would not allow the IP address and the Gateway to be the same. So I tried:

IP address:  192.168.1.1
Gateway:     192.168.1.10

No go.

Then I tried

IP address:   192.168.1.10
Gateway:     192.168.1.1

Still no go.

I then tried

IP address:   192.168.10.108 
Gateway:     192.168.1.1

And

IP address:   192.168.1.1 
Gateway:     192.168.10.108


Why can't I get to the config page?? Any suggestions?

Thanks