Quote from: aminkorea on December 31, 2013, 11:41:39 PM

Quote from: mchu168 on December 31, 2013, 11:38:54 PM

Quote from: aminkorea on December 31, 2013, 11:30:31 PM

Hello everyone. It's me again. I am still having trouble getting my second cube connected. By that I mean I still cannot get to the config screen to set up the cube. Here is what I have done this morning.

1. Plugged in the PCI power cable from my 1000 watt Zalman PSU
2. Plugged in the ethernet cable.
3. Powered on the PSU. All lights indicate on and running.
4. Pressed the Factory reset button for a few seconds (red light flashed a dozen time or so and then went steady red)

I pushed the factory reset because I had entered the config page a few days ago and changed the IP. Then when I tried to access it again, I couldn't. So I want to start from the beginning.

5. Opened my TCP/IP configuration and change the settings to:

IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1

I then pointed my browser to 192.168.1.254:8000

The browser gave me an error page. So, I use the command prompt to check the ip config.

C:>ipconfig

Ip address: 192.168.1.1
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0

So, it was clear the computer would not allow the IP address and the Gateway to be the same. So I tried:

IP address: 192.168.1.1
Gateway: 192.168.1.10

No go.

Then I tried

IP address: 192.168.1.10
Gateway: 192.168.1.1

Still no go.

I then tried

IP address: 192.168.10.108
Gateway: 192.168.1.1

And

IP address: 192.168.1.1
Gateway: 192.168.10.108

Why can't I get to the config page?? Any suggestions?

Thanks

How is your LAN setup? Do you have a DSL or cable modem connected to a wireless router?

I have a cable modem connected to a wifi router. The thing is, I have set up one cube already and used the same procedure. It worked on one, why not the second one?

I really have no idea, as I don't know what you've tried, changed, etc. Can you access your wifi router setup page. Usually you can type in the gateway ip address into your browser to access it. Depending on the make, the login is usually admin with no password. Sorry if you know this already, but it seems like you need to go back to square one.