Quote from: alexrossi on January 02, 2014, 04:02:01 PM

Quote from: stex2009 on January 02, 2014, 03:57:28 PM

Quote from: alexrossi on January 02, 2014, 03:52:40 PM

0.01 BTC if someone will resolve my problem before 23.00 UTC of 02/01/2014

I have a big problem: i'm trying to fire up a cube, i have a coolermaster v700 (58A on the 12v rail), with the fuse the miner start and after a few second it shutdown, without the fuse the miner starts but the leds are all off and also if i try to navigate on 192.168.1.254:8000 the browser doesn't load anything...

Did u try taking out the blades and pluggin them one by one to make sure each one runs on its own on the cube ? That might help if u haven't.
So, first run the cube without any blades. If it doesn't power, u have a faulty cube. Then start one blade at a time.

Now i have two cubes, and both have the same symptoms: shutdown with the fuse, no leds w/o fuse, the v700 is NEW and as mentioned before, has 58a on the 12v

it's really worthy open the cube to remove ALL the blades?

Yes. You have to remove the end plates and unplug the fan. The push the blades and card out of the case. Remove each card and make sure the screws holding the heat sink are securely in place. After you have tightened all the screws, reseat the blade back onto the bottom board.

Next reinsert the blades back into the case. Connect the fan and secure the fan plate to the frount of the cube. Make you that you get the red status light in the hole next to the ethernet connection. This can be a little tricky, but it is important that it is done correctly or you may damage the lead.

After installing the front plate, put the back plate on the back of the case. If all went well, you are now ready to configure the cube.