Quote from: cryptoculprit on August 14, 2018, 01:12:20 PM

Quote from: craigh on June 12, 2018, 06:24:00 AM

Quote from: michele1it on June 11, 2018, 09:16:51 PM

Quote from: cryptoculprit on June 11, 2018, 01:43:08 PM

I added 10 "ENABLED" nodes to my arcticcoin.conf, deleted gmcache.dat and peers.dat as suggested and restarted the wallet, but same issue persists. "No Block Source Available". I too am using it just for learning about masternodes, it would be nice to get it working again if you have any other suggestions.

I understand your disappointment, unfortunately I have no other suggestions to give you and although I may seem pedantic and repetitive I assure you that even today I opened the wallet several times and it worked, as always synchronizes with at least 15 or 17 peers within minutes from opening of the wallet. That's all!

You are probably on a fork. Only way to fix this now that you have added valid nodes:

Close your wallet
Delete %appdata\arcticcore\peers.dat
Delete %appdata\arcticcore\blocks (folder)
Delete %appdata\arcticcore\chainstate (folder)
Open your wallet
Wait for full sync. This could take a few hours!

C.

For those having issues syncing your wallet still, try this - worked again for me just now, my wallet is syncing again. Make sure you follow michele1it's instructions to add some valid (ENABLED) nodes to arcticcoin.conf first.

You can just reindex blockchain, its not a problem. Where you got working nodes? Enabled nodes which shows in the your not synced wallet can be in wrong chain.