Quote from: Dobryj77 on October 04, 2018, 09:57:12 AM

Quote from: imine2 on September 30, 2018, 04:46:27 PM

Quote from: Dobryj77 on September 30, 2018, 03:47:09 PM

Quote from: imine2 on September 30, 2018, 09:14:03 AM

Quote from: Dobryj77 on September 30, 2018, 08:16:12 AM

Hello, I changed the firmware to batch 1 after 24 hours the miner was cut down and no indicator is working. Now I can not enter the admin panel of the miner. Can you tell what can be done about it?

fan running Huh

heat?
Power working at all Huh

?

Yes fan and power supply working.
Do you think that I can try to recover from the SD card Huh

Have you tried this method?

https://support.bitmain.com/hc/en-us/articles/115003595387-How-to-reset-miner-to-factory-settings-
(Depending on where your SD-cardslot is placed you will use method 1 or method 3, read instructions in link for method 1 and 3 to decide which alternative is valid in your case.)

Recover from SD-card should be last option, I think!

Hi. The miner does not start the SD card not work indicator light, but the cooler is spinning.

Have you tried the method 1 or 3 whichever valid in your case using the "reset"-button function ? ? ?

Have you tried having power only connected to controllerboard ? ? ?

Have you carefully tried moving all of the cables to check if you have bad connection somewhere ? ? ?

does fan speed up max and then go back down and automatic adjust fan speed Huh

IF it does then that part of firmware must be working(running) and adjusting according to temp measured from each hash-board.

can you measure power usage from wall socket to PSU ? ? ?
How much?

AND the firmware you used, was it correct: may 26 2018 version Huh

Method : 1. Restore via Reset button

(This method can be applied within 10 minutes when the miner boots.)

After powering on the miner for 2 minutes, please press "Reset" button for 5 seconds, then release it. The miner will be restored factory settings within 4 minutes and automatically restart (no need to power off the miner).

Method : 3. Restore via IP Report button

(The miner will automatically revert to factory default firmware)

This method is only applicable to the miner which with the SD card slot on the left of Ethernet interface.

Please power off the miner, then hold down the IP Reporter and dont release it. At the same time, please power on the miner. Releasing the IP Reporter after 5 seconds, the machine will automatically restore factory settings.

NOTE: This method is not applicable to the miner which has a SD card on the right of the Ethernet interface.