Quote from: cyberunknown on October 08, 2018, 04:13:26 PM

Quote from: crypper on October 08, 2018, 03:52:54 PM

Quote from: cyberunknown on October 08, 2018, 03:45:29 PM

Quote from: Silverhydra57 on October 08, 2018, 01:57:53 PM

Hi,
Sorry if the problem has already been solved, I did not read the entire thread.

I am willing to give this miner a try but it draws far more power than claymore for a similar or little higher hashrate.

I use it with win10 with 6 RX580.
With claymore (11.9), 186Mh/s @ 830W
With Phoenix (3.5d), 187Mh/s @ 1150W!
I tried to use the same values for clocks and voltages (which are set in config.txt) or to let it blank without any effect.
What am I doing wrong?

Install latest version of AMD drivers then switch to compute mode.

So you assume that he got 187 Mh/s from 6xRX580 with compute mode off? Shocked

I think noobs account should not be allowed to give advice, only ask...

to answer OP: looks like clock and/or voltages are not properly applied, because power draw for phoenix is about the same as for claymore. And with that I refer you to posts on this and previous page: "ALWAYS use 3rd party soft to control clocks, power and fans: OverdriveNtool for red and nvidiaInspector for green; don't use AB - it's shit. Don't use miners for controls."

He used Blockchain driver.

That's right I use Blockchain drivers, I'll try with latest AMD drivers then and if that fails, I'll use OverdriNtool to control parameters (even if I prefer to apply it through miner).
Thanks a lot, you're both very helpful.