When you create your masternode, you enter a command "getaccountaddress MN1" (or you replace MN1 with anything you want, call yours DERP1 if you want to). That getaccountaddress command gives you the address you send your collateral to, but it also tells your wallet the name of your masternode. That is how you name your masternode. Then the masternode.conf file references that same name. Your masternode.conf file will then have a line that says "MN1 129.125.72.152:9009 YOURPRIVATEKEY MASTERNODEOUTPUT TXID" only those last three variables are replaced by whatever your values are. That's it. You might be making it harder than it actually needs to be.
Moved 1000 helium to 1 address
I've done all config file edits on both controller wallet and masternode wallet.
Ran that command in both wallets.
still get... "Error reading masternode configuration file: could not parse masternode.conf Line 1 "MN1" "
(or whatever I call it. It won't parse 1st line. I have to un-edit file back to launch wallet)
So I guess I'm missing something fundamental here.
derp derp derp... I give up.
I will tip any masternode geniuses who can figure out wtf I'm doing wrong.
MN1 00.000.000.000:9009 xxxxxxdrtiuldfkjdfildfliluilu8UIUIDHILcJFUghhgxx f2c5bbbc2f981bb164doifdljifjildluiO576e3JHKKJH455646529fee5f07855f 1
i made with accept payment a address and sent there the 1000 helium i never used the getacccountaddress in the debugconsole..