Quote from: mattaero on November 02, 2018, 06:12:57 PM

Quote from: hobbyguy242 on November 02, 2018, 05:59:52 PM

Quote from: mattaero on November 02, 2018, 02:57:49 PM

Quote from: vincl on November 02, 2018, 02:44:26 PM

today i tried to setup two Z1s but NONE of them is hashing -.-

tried different firmwares, all the same "

no graph is loading.. "The miner may not boot"

WHY THE FCK???

pools are nicehash..anybody else had the problem?
maybe pendrives are too slow? when i write image i only get about 3-5MB/s...so quite crappy ones

im not stupid. i know how to setup asics but this piece of shit drives me crazy..so time consuming.. thanks god these are not my personal units

Maybe the USB drive. But when I did it, I found I had to use Imageusb.exe everal times to get it to work right. I also found I had much better success with the original firmware than the later ones... It took the overclock setting much better for me.

I also had lots of issues with nicehash, though others don't seem to. I had like 10-15% stale shares.

I saw a ton of discussion about overclocking these, but Im fairly new to mining. Do you know of any place that has a good tutorial or instructions on how to overclock the z1/z!+?

Go to earlier in this thread. You change the frequency to 1000 among other changes.

Do you know where exactly? I looked through it and there are a ton of various conversations about it. And being that Im new to this, most of the terms that they are using are very unfamiliar to me. I just want to make sure that if I do overclock it that I do it 100% correct so I dont do any damage to the unit.