Much better, looks like you now have 12.5 units functioning, 3.5 not working. Not sure what you mean by "concrete worker" though... 5 and 6 should be near the ribbon cable, so my guess is for those two, the board probably has got the capacitor problem (due to ribbon cable forcing a capacitor to come loose). 12 may be the case on the other blade. Not sure about 2 though - could be that was one that you thought the fuse was OK, but is not? There have been cases of misaligned pins in the backbone board that goes atop the blades, with pins even being bent outside the connector, so it might be worth a close inspection all around, both for loose capacitors and bad connections on the backplane.
K, I repair some fuses arent connect so I create baypases, and now i have like this:
It is some possible to locate concrete worker ?
[STATS] => 0
[ID] => AVA0
[Elapsed] => 479
[Calls] => 0
[Wait] => 0.000000
[Max] => 0.000000
[Min] => 99999999.000000
[baud] => 115200
[miner_count] => 16
[asic_count] => 10
[timeout] => 9
[frequency] => 1400
[fan1] => 0
[fan2] => 3240
[fan3] => 3000
[temp1] => 24
[temp2] => -1
[temp3] => -1
[temp_max] => 24
[Device Hardware%] => 10.4575
[no_matching_work] => 247
[match_work_count1] => 1618
[match_work_count2] => 0
[match_work_count3] => 1492
[match_work_count4] => 1537
[match_work_count5] => 731
[match_work_count6] => 0
[match_work_count7] => 1534
[match_work_count8] => 1528
[match_work_count9] => 1535
[match_work_count10] => 1373
[match_work_count11] => 1561
[match_work_count12] => 0
[match_work_count13] => 1586
[match_work_count14] => 1471
[match_work_count15] => 1088
[match_work_count16] => 1475
[Controller Version] => 0
[Avalon Chip] => 55
[USB Pipe] => 0
[USB Delay] => r0 0.000000 w0 0.000000
[USB tmo] => 26726 0