I went and did something stupid I guess because my box will not respond. I re-flashed the box and forgot to unchecked the settings box. I could not reach the box and it would not ping. I did a reset of the board, changed my nic and plugged the miner into my notebook. Still no ping. Powered down and back up still no ping. It just sits there in idle mode...yellow and green leds lit and a slow 1 sec. pulse coming from the on-board nic.
Is there a way to force flash these things without using the web interface? Googled a for a while but did not find the answer.
Thanks ahead of time for any info or
a finger point in the right direction...
search this thread for "failsafe".
Ok...looks like I am in? I can telnet into the box It says at top to use passwd to set password. I followed this site
http://wiki.openwrt.org/doc/howto/generic.failsafe. But it just stays in failsafe mode.
I bounce the box but it just stays at 192.168.1.1 and I can telnet and SSH to it. So I downloaded the latest avalon firmware, but I am not a linux guy...is it possible to flash the firmware using the .bin file from a telnet or ssh session? I don't have a lot of coin but am willing to send a C note to whoever can work me through getting this this back online and hashing. Please Pm me so we do not clutter this thread.
Thanks