Quote from: yonydouna on December 26, 2018, 10:46:39 PM

Quote from: mikeywith on December 26, 2018, 10:32:38 PM

Quote from: yonydouna on December 26, 2018, 10:25:53 PM

1) While I am editing, can I close and open the PuTTY without danger while I have not saved the changes? (:wq)

2) Assuming the worst case, if a mistake is made, is it possible to reverse it? reinstall the firmware, set it factory default, and start over?

1- yes if you use the "x" bottom on top ,the setting won't be saved.

2- in theory the worst case scnerio is that you'll need to reset the miner. but still shit can happen.

since you are not going to do any coding , you shouldn't make any mistake, before you save just revise the code 2-3 times, compare it to the prev code you pasted here, make sure you have not deleted anything.

Ok, I ask you this since tomorrow I will post the edition step by step what you told me and ILL NOT SAVE THE CHANGE until you first see the code / photo and give me the approval. Wink

WORKS!!!

at the beginning after modifying the codes and saving the pages I continued to restart the antminer and then again but this time doing the flashing, it did not work and when I checked the pages inside the PuTTY I realized that the codes were the same as before modifying them, seem when you reset the antminer (digitally) the codes return to their originality, given that I did the same thing again but this time I saved the codes and closed the PuTTY I went to flash it (with the firmware MOD) this automatically reboots and ready , I had installed the Blissz Firmware.

https://imgur.com/a/mJszoKB

What surprised me the most was how ridiculously easy it was to do all this for what it cost me to understand at the beginning.

I want to thank you mikeywith for having helped me and have patience for this, and wish you a happy new year