Quote from: crairezx20 on January 18, 2019, 05:48:14 PM

Did you try to factory reset the miner? There is a small hole for the reset button and hold it for 15 to 20 seconds then release wait for a couple of minutes and try to scan the IP again.

Also, you can check the guide on how to flash this miner to stock firmware check this link https://www.cryptominerbros.com/dayun-zig-z1-firmware-upgrade-guide

Hi crairex20,

Yes I tried to reset the machine by holding the reset button for 15-20 seconds but nothing seems to happen, I am unable to connect to the ip address because it won't show up. (I use my pc that is directly plugged into the rotor so I should be able to see every IP that is connect to my internet/rotor correct)? (I also use advanced ip scanner to search my addresses) I tried burning another flash drive but that did not work for me, maybe I didn't download the correct version. Do you know how to download the stock settings. I simply need to get back onto the original IP address that my machine is on so I can connect to it and update the firmware. Could the machine also have a broken hashboard or maybe a broken controller board?

Jamie