Quote from: Protagonus on February 10, 2014, 05:07:21 AM

Quote from: stewart2012 on February 10, 2014, 04:49:37 AM

Quote from: Protagonus on February 09, 2014, 11:54:33 PM

Quote from: stewart2012 on February 09, 2014, 11:40:05 PM

Quote from: Protagonus on February 09, 2014, 11:13:57 PM

need to add --failover-only end of line ?

It can go anywhere after the pool entries. In fact you don't "have" to add it, but many do. You could have it in the middle though, doesn't matter:
This is my config for 7950's
failover is in the middle

thanks again ... but if i dont use from this parameter , auto switch is disabled ?

If you list multiple pools, it will switch to them either way. For a better description; Might as well hear it "from the horses mouth" so to speak. The Dev for CGminer

Quote from: ckolivas on April 03, 2012, 06:06:44 AM

The normal failover mechanism in cgminer will allow some work to go to the backup pools if there is a delay in getting work from the primary pool you have set. This can be as much as 10% if the pool has latency issues. It then only fails to the backup pool if the primary pool stops giving work for 1 minute. failover-only does not change the failover mechanism, but it does not allow work to go to the backup pools unless the primary pool has failed completely for at least a minute. It then will switch to the backup pool. If cgminer considers a pool dead or down, it tries to contact that pool 1 minutely.

hope this helps

thanks alot my brother ... very helpful .