Quote from: akvilon888 on April 23, 2019, 01:50:17 PM

Quote from: kerney666 on April 23, 2019, 01:14:34 PM

Quote from: akvilon888 on April 23, 2019, 12:10:11 PM

Quote from: MaxHa$h on April 22, 2019, 02:31:45 PM

Quote from: akvilon888 on April 22, 2019, 01:03:29 PM

hi, what command i have to use to restart miner if some gpu failed ?

create a batch file and name it

you can use this in the file

SHUTDOWN -r -t 10

watchdog="filename"

as i understand it will reboot my rig, not miner ? how can i restart only trm if some gpu dies?

The problem is that the driver might be in a corrupt state, and the miner can't shut down cleanly. On my own rigs, I need to reboot anyway in 99% of these cases.

That said, my experience is that the win driver(s) recover somewhat better for Polaris cards. If you know you'll get a clean shutdown and always can just restart the miner, I would define a watchdog.bat file in your miner dir that (1) sleeps for 20 secs or so, (2) runs your normal startup procedure (resets clocks for all gpus, start the miner, etc). Last, you also need to add the command line arg --watchdog_script when starting the miner.

The procedure when a dead GPU is detected is that the miner will both execute your watchdog script and then shut down. The 20 sec sleep in your watchdog should catch any unexpected wait times during the miner exit.

dont know why, but after some time one of gpu's dies, it is always fifth cards, and i just close trm and start again, and it starts to mine normaly, but then it happens again after some time...( cant understand why...

Lower your clocks on that 1 card or change your memory tweak settings if using. Not all cards are the same when pushed close to the edge