Quote from: UnclWish on May 07, 2019, 08:41:52 PM

Secure boot didn't allow to load unsigned drivers with UEFI bios.
I tried to run miner with admin rights but I got error:
In log:
23:39:57:796 4e14 Driver is not installed! Trying to install it...
23:39:57:854 4e14 Failed, you must run miner with admin rights.
On screen system error message appears before "Failed..."
"Value protected by secure boot policy and can't be changed"

Oh, you are correct, I completely forgot how it must work.

Quote from: davescream on May 07, 2019, 08:47:44 PM

If you spend so much time, how is the fastest way to found the best strap/mem clock?
Is there way to found max mem clock without restarting whole miner? As I remember, when I overclock memory, hashrate go up only after restartminer... so restart miner every time is slow... maybe you found beter way for fast applyong new memclock and see new hashrate without restarting miner?

I spent much time in attempts to implement this trick, not in overclocking. Anyway, use WattMan or AfterBurner for overclocking. Put hdmi dummy plug into card and it will apply new clocks immediately. Or set new clock and disable GPU in the miner ("0" key for first GPU, "1" for second GPU, etc) and wait until memory clock will go idle (in a few seconds), then enable GPU again in the miner, new clock will be applied after that.