Quote from: sidehack on May 16, 2019, 01:54:59 AM

Gosh dangit, another one? See I've run every single one of those pods at least six separate times during different testing steps, including a burn-in test for 24 hours, and have yet to see it happen once.

I'll work on a firmware fix that makes "temp sensor is no good" blinking distinct from and much less obtrusive than "temperature is too high" blinking. And figure out why the heck the temp sensors are failing in these things. Heck I may just get rid of them entirely.

Also when I say "firmware fix" I mean literally a code change for the onboard microcontroller. What makes lights blink is completely independent from cgminer.

By the way, that condition's already been talked about so looking back in the thread a bit will catch you up.

Thanks @sidehack .
I do see where @kingofhammers had this issue, however if you look at the paste of cgminer (trying) to run, you will see that I get failures on GSI 0, GSI 1, and GSI 2, -- the unit settles at 0 chips found after resetting all the ASICs and the unit is never hashing.

I did rebuild cgminer using the May 14th build, so it is not the software.
Very frustrated at this point.