Quote from: jstnryan on May 29, 2019, 03:18:36 PM

After setup (my Apollo is working fine), I have port-forwarded from the WAN side of my router to the Apollo portal, but it always displays the "Initial Setup" modal, blocking the login form. The expected behavior was that I would be able to log in and configure as usual. I'm hesitant to do the 'initial setup' again, because I don't want to overwrite my existing setup. Did I miss something, or is this a bug?

Does this occur when you only access the Apollo from outside your local network, or does it happen from your local IP as well? If it only happens outside it could be a bug, as I have not tested this case.

If its happening in both cases then sounds like the SD card got corrupted and is not accessing your already configured flag.