Quote from: klondike_bar on February 15, 2014, 02:58:52 PM

Quote from: smithytzu on February 15, 2014, 06:29:04 AM

Quote from: BitcoinValet on February 15, 2014, 04:26:43 AM

Ok, so I was able to factory restore by following directions on here, but now I am back to my original problem.

I am following the directions in the op, but when I manually input the ip address into IPv4, my computer cannot connect to the internet. I can interface with the antimner without changing my ip settings by navigating to 192.168.1.99, but it is not mining after I input and ave my pool settings.

What's your modems IP address?

Go to the ant miners network config page, make sure the gateway (your modems ip) is correct the primary DNS should also be your modems ip, go to the ant miners network diagnostics page and run both ping and DNS tests, if they work you're antminer is connected to the internet and good to go.

with the default settings, clear the field for 'ipv4 boradcast' and set DNS to 8.8.8.8

I tried this, and I also followed smithytzu's instructions. The gateway was different than that of my computer, so I changed it.

The ns lookup fails with the following error;
Server: 127.0.0.1
Address 1: 127.0.0.1 localhost

nslookup: can't resolve 'openwrt.org': Name or service not known

the ping fails saying;
ping: bad address 'openwrt.org'

I have not changed anything in my network settings on my computer, because if I de-select automatically obtain and manually input anything, my internet connection drops off.

Here are some screenshots of what I am looking at. Any help is appreciated.
http://imgur.com/a/Dldhr