Quote from: Yinero on February 22, 2014, 06:57:45 AM

Quote from: Yinero on February 16, 2014, 12:08:00 AM

So I have 2 blades that I was reconfiguring. I changed there IPs to a different one. I usually only change the last number, like 192.168.1.25X. I've done this many times over and now they wont respond when I open them...

I also have 2 cubes running and both of them I am able to configure just fine. All I did was change 1 ip to 254 which is the default... and the other to 256 and now they are both unable to connect.

Quote from: dogie on February 18, 2014, 03:54:29 PM

See my sig for link to the setup thread, and diagrams of the pins (make sure you're doing the right pins for V2s). Also remember to do it while they're running, those are the two most common mistakes.

If you still have no luck, post in the thread and we will sort you out.

This quote is from my thread I started about having problems resetting the IPs on my V2 blades.

Now, I've read your guide and it is how I initally set them up while they were working. I also have tried resetting them with the pins and while it was on. I used a piece of wire for that and it didn't do anything. They are still coming on and all the lights show them as OK. I cannot access the configuration menu now however.

I also have tried running them 1 at a time and still nothing is showing up when I type in the new IPs I have set for them. This all didn't start happening until I changed the IPs. I don't know if I did reset the pins wrong or what. I followed everything exactly as it showed it. My blades have been sitting here for 2 weeks now doing nothing... atleast my cubes work but I still need these blades functioning ASAP.

Check with your router that the address range can go that high, some only have a partial range as default. But almost certainly 256 was out of range.

Remember to only have one plugged in if they're both reset as they'll both try and get on .254.