Quote from: NotFuzzyWarm on August 19, 2019, 02:37:21 PM

Thank you for the 1st useful info about it.
I had a feeling that it might be an existing firmware that has been re-skinned. I'll keep this thread open for the rest of the week but if there is no further input, after the week is over I'll be locking the thread.

Well nothing much to say, decent firmware doing what is supposed to do (must admit like it more the BraiinOS) you could keep it open in case something new pops up. For now people might share there settings since orginal AM thread is filed with GPU talk.

Quote from: VTdude12 on August 20, 2019, 01:40:43 AM

What settings did you use to achieve this result? Been playing around with diff auto-tune settings, but haven't been able to get my W/Th that low. Thanks!!

set chains to 640~650 and voltage per chain 8.4, do the chip auto tune in steps of 2 and 2 min also mark "Reset chip freq and clear log (set all chip to global freq)". also set "HR from ideal" to 80%.

Depending on the quality and condition of your ASICS this can take from 30 min to 6 hours.

After you done on mining status window you can check which chain is the closest to ideal, in most cases that chain can be further undervolted to 8.3 (even 8.2) with out crossing the 80% mark from ideal hashrate.

Some miners can handle this some don't, found this to be the optimal setting. Some claim that on higher freq you can achieve even better Th/W ratio but its summer (and a very hot one in EU) so didn't try it yet.